About this guide

2024-11-19Last updated

This manual describes how to enroll and configure the Axis Powered by Genetec door controllers in Security Center. It assumes that you are familiar with the AXIS device interface and the Security Center platform, more specifically, with the Synergis™ access control system.

This guide supplements the documentation provided with Security Center and your Axis Powered by Genetec door controller user manuals, and assumes that you are a certified user of Security Center, Synergis™, and Omnicast™, and that you are familiar with the configuration and use of the following:
For late breaking news, known and resolved issues, see:
  • Axis Powered by Genetec Release Notes for A1210
  • Axis Powered by Genetec Release Notes for A1610

Terminology

In this document, the terms door controller, device, and unit all designate a network door controller device. However, the term unit is preferred when the device is enrolled in Security Center as an access control unit.

Notes and notices

The following notes and notices might appear in this guide:
Tip
Suggests how to apply the information in a topic or step.
Note
Explains a special case or expands on an important point.
Important
Points out critical information concerning a topic or step.
Caution
Indicates that an action or step can cause loss of data, security problems, or performance issues.
Warning
Indicates that an action or step can result in physical harm, or cause damage to hardware.
Important: Content in this guide that references information found on third-party websites was accurate at the time of publication, however, this information is subject to change without prior notice from Genetec Inc.